WideLine-8
WideLine™ Line Array Speaker System
Features of the WL3082
WL3082 | WL212-sw
• Extraordinarily compact (only 20"/508 mm wide) and lightweight
(38 lb/17.2 kg)
• High acoustic output (133 dB SPL peak)
• Wide 140° horizontal coverage
• High power, 8" neodymium LF/MF drivers provide low-frequency extension
to 62 Hz without subwoofers
• 3" diaphragm compression driver on QSC’s patented 140º multiple diffraction
aperture waveguide (Patent No. 7,177,437)
• Simple, easy-to-use rigging system supports arrays of up to 12 units with
10:1 design factor
• Flexible ground stack capability
• Fully supported in EASE and EASE Focus acoustic software
Features of the WL212-sw
• Dual 12" subwoofer in a 4th order bandpass enclosure
• 135 dB SPL peak output capability
• Frequency range to 32 Hz (-10 dB down point)
• May be suspended at the top of a WL3082 array or behind the array
• Integral suspension hardware also supports WL3082 in ground stack applications
Designed for the most demanding concert and installation audio
professionals, the WideLine-8 system sets new standards for astonishing
acoustical performance and compact size.
The WideLine-8 sub sets a new benchmark for extraordinary acoustic
Line arrays are increasingly employed in a wider range of venues and
applications. Frequently these venues have height or sightline restrictions
that limit the placement and size of the array. Rising fuel costs are putting
pressure on touring system providers to downsize their transportation
requirements. At the same time, client and audience expectations for
audio performance has never been higher. To meet these needs, QSC
embarked on a program to develop the most compact, highest output line
array speaker system available.
output from a miniscule enclosure. At first glance, the enclosure seems
too small to even house its pair of 4" voice-coil, long-excursion 12"
woofers, yet it produces 135 dB (peak) SPL and has LF extension to
32 Hz, with the punch needed for popular music. The extremely low
profile of the WL212-sw sub (less than 15") also makes it a great choice
for installed and portable use under a stage or in other tight quarters. The
4th order bandpass design matches the width of the WideLine-8 elements
allowing it to be flown inline with or behind a WideLine-8 array.
QSC’s WideLine-8 packs full size line array performance into an ultra
compact package measuring less than 20" (508 mm) wide and 9"
(229 mm) high. The WideLine-8 applies to audio the classic hot rod, high-
performance formula – putting the most horsepower available into the
smallest chassis possible.
Premium materials are used throughout the system. The enclosure is
constructed of Baltic birch plywood and coated in an environmentally friendly,
waterborne polymer finish that is field repairable. To keep the weight to a
minimum and prevent rust, suspension fittings are made of aluminum.
An elegantly simple 4-point suspension system combined with light weight,
compact size and excellent handling ergonomics mean that a one person
crew can easily deploy an array. A single AF3082-L array frame suspends
up to twelve line array elements or up to twelve line array elements plus
four subwoofers. The WideLine-8 system is equally at home in the air or
ground-stacked.
Each tri-amplified WideLine-8 element uses a pair of high-power,
neodymium magnet, 8" low-frequency drivers. Both cover low frequencies
while only one extends into the mid range, thus maintaining horizontal
dispersion control at crossover. High frequencies are handled by a
premium, 3" diaphragm, neodymium compression driver mounted to
QSC’s patented, 140º multiple aperture diffraction waveguide. WideLine
signature wide coverage delivers a broader stereo image, reduces the
need for supplemental fill speakers and allows more placement options.
Special attention is given to ground-stacked applications. The WideLine-8
sub suspension system includes a unique provision that allows the lowest
line array element stacked over a sub to be tilted up or down by as much
as 10º, offering better coverage of listeners near the stage. WideLine-8
subs may be used as a base for stacking up to six WideLine-8 elements.
The waveguide exit extends nearly to the top and bottom of the enclosure to
create a continuous acoustical source with minimal discontinuities between
adjacent elements resulting in greatly reduced destructive interaction.
Specifications | Signal Processing
WL3082
WL212-sw
Configuration
Transducers
Dual 8", 3-way, tri-amp line-array
Dual 12", 4th order bandpass subwoofer
High-frequency
Low-frequency
3" diaphragm, neodymium magnet compression driver
Dual, 8" woofer, 2.5" voice coil
—
Dual, 12" woofer with a 4" voice coil, ceramic magnet assembly
Frequency Response ( 3 dB)
Frequency Range (-10 dB)
Nominal Impedance
68 Hz – 18 kHz
62 Hz – 20 kHz
40 Hz – 100 Hz
32 Hz – 107 Hz
HF: 16Ω
MF: 16Ω
LF: 16Ω
SUB: 4Ω
Continuous Power Capacity1
Sensitivity (1 W at 1 m)
HF: 85 W
MF: 250 W
LF: 250 W
LF: 1100 W
HF: 108 dB SPL
MF: 98 dB SPL
LF: 98 dB SPL
LF: 99 dB SPL
Maximum Output, Continuous/Peak
(dB SPL at 1 m)
HF: 127 dB SPL / 133 dB SPL
MF: 122 dB SPL / 128 dB SPL
LF: 122 dB SPL / 128 dB SPL
LF: 129 dB SPL / 135 dB SPL
Nominal Coverage
H: 140°
—
—
V: dependent on number of elements used
Enclosure Type
Enclosure Material
Finish
Ported, trapezoidal
4th order bandpass
15 mm birch plywood
15 mm birch plywood
Available in black (WL3082) or white (WL3082-WH) paintable
Perforated, 16AWG steel, backed with black/white cloth fabric
2 x NL8 in parallel
Available in black (WL212-sw) or white (WL212-sw-WH) paintable
Grille
−
Connectors
Pin Outs
2 x NL8 in parallel
1+/1- NC; 2+/2- LF; 3+/3- MF; 4+/4- HF
1+/1- Sub; 2+/2- NC; 3+/3- NC; 4+/4- NC
Integral, non-adjustable
Attachment Points
Integral, side plate adjustable rigging system, vertical splay adjustable
in 1° increments from 0° – 10°
Weight (Net / Shipping)
Dimensions (HWD)
38 lb (17 kg) / 45.5 lb (20.7 kg)
109 lb (49.4 kg) / 125 lb (56.7 kg)
9" x 20" x 16"
15" x 20" x 29"
229 mm x 508 mm x 406 mm
381 mm x 508 mm x 737 mm
Available Accessories
AF3082-S • AF3082-L • EB3082 • CP3082 • PB3082 • AF8-10
AF3082-L • CP212 • AF3082-S
See descriptions on back
1) 2 hours, IEC specified noise
Specifications subject to change without notice.
WideLine-8 Signal Processing
TheWL3082isdesignedfortri-amplification. AddingWL212-swsubwoofers response and extremely natural, uncolored sound across its frequency
band and coverage area. An array of loudspeakers with Intrinsic Correction
tunings will be very responsive to the use of equalization to compensate
for array configuration, acoustical conditions or user preferences. For users
needing sophisticated, programmable DSP, voicings are available for QSC
BASIS™ processors.
creates a 4-way active system. For applications in which audio quality is
paramount but operational simplicity and low-cost are also critical, the QSC
SC28 processor delivers factory programmed voicings while also offering
user-adjustable system equalization, offset delays and output levels.
QSC system engineers have employed the power of the SC28 processor’s
FIR (finite impulse response) filters to implement Intrinsic Correction™ of
the loudspeaker. Intrinsic Correction provides the most accurate acoustical
magnitude, frequency and phase domain performance possible. Intrinsic
Correction can compensate for many causal phenomena such as the
effects of waveguide acoustical impedance and loudspeaker cone
resonance. The result is a loudspeaker system with excellent power
SC28
BASIS 914lz
Dimensions | Accessories
WideLine-8
WL3082
21.7"
551 mm
16"
406 mm
19.9"
505 mm
9"
228 mm
Front
Side
Bottom
Top
Back
21.7"
551 mm
WL212-sw
29"
736 mm
20"
505 mm
15"
15.2"
380 mm 387 mm
Front
Side
Bottom
Top
Back
AF3082-L
EB3082
AF3082-S
Large array frame, supports up to twelve (12) WideLine-8
elements and four (4) WideLine-8 subs with 10:1 design factor.
Extension bar, required for system with
the subwoofers flown behind the main array.
Small array frame, supports up to twelve (12)
WideLine-8 elements with 10:1 design factor.
AF8-10
PB3082
CP3082
CP212
Adapter frame that allows suspension
of WL3082 under WL2012.
Pullback bar for adjusting aiming angle
of WideLine-8 arrays or suspension of
certain small arrays.
Caster pallet for four (4)
WL3082 line array elements,
includes padded cover.
Caster pallet for three (3)
WL212-sw subwoofers,
includes padded cover.
Specifications subject to change without notice.
© 2009 QSC Audio Products, LLC. All rights reserved. QSC, the QSC logo, WideLine and BASIS are registered trademarks of QSC Audio Products, LLC in the U.S. Patent and
Trademark office and other countries. Intrinsic Correction is a trademark of QSC Audio Products, LLC. All other trademarks are the property of their respective owners.
Patents may apply or be pending.
qscaudio.com
1675 MacArthur Boulevard • Costa Mesa, CA 92626 • Ph: 800/854-4079 or 714/957-7100 • Fax: 714/754-6174
WideLine-8 Spec Sheet 05/26/09
|
Panasonic EZANC User Manual
Panasonic DMCSZ8K User Manual
Panasonic AG HVX200A User Manual
Oster Blender 153034 000 000 User Manual
Olympus PFL 01 User Manual
Nikon D70S User Manual
KitchenAid 4KFP720WH0 User Manual
Kenwood KDV C810 User Manual
Kenwood KDC V7017 User Manual
JVC KD G400 User Manual